- 3/32″ through 3/8″ diameter capacity through two different
hand
tools.
- Removes titanium fasteners in 8 seconds, removes aluminum
fasteners in three seconds!
- Virtually eliminate aiframe damage resulting from current
mechanical removal processes.
- Removes most fastener types; hi-loks®, lockbolts,
jo-bolt/visu-lok/ composi-loks, eddie-bolts®, blind bolts, solid
rivets!
- Removes from either head side or collar / bulb side.
- Cuts any conductive metal – aluminum, titanium, stainless,
inconel, etc.
|
The E-Drill is aircraft safe. Risk of damage tounderlying
panels is
dramatically reduced by E-Drill’s depth of cut control which is
accurate to .005″. Enabled by the patented hand-held EDM (Electro
Discharge Machining) technology, the new E-Drill removes fastener
locking components allowing for their removal. The cutting process is
forceless, eliminat-ing cutting tool drift and drill slip damage. |
Benefits of the E-drill
- Fastener removal in seconds vs. minutes!
- Non-mechanical system virtually eliminates air-frame damage.
- Low temperature – no damage to composite surfaces.
- Eliminates potential eye injuries from chips in overhead
fastener
removal applications.
- Reduces repetitive motion injuries.
- Reduced operator training – days vs. months.
- Reduces operator skill or strength necessary.
- Supervisory control of use and work settings.
- Onboard diagnostics remotely diagnose failures.
- Improved quality control processes.
- Closed-loop system captures contaminants.
- Reduces FOD.
- Reduces AOG time and improves capital asset utilization!
|
 The New EG Series gun (external ground) has the capability of smaller fasteners from a 3/32″ to 1/4″ diameter. With an upgrade kit that is available, the new EG Series gun is compatible with existing mobile service units (MSU) serial numbers 46 and higher currently in the field. |
   |
Call for information to set up an on-site demo of the e-drill
today! |
